W619032RSR Quality Budget Stainless Steel Rubber Sealed Thin Section Deep Groove Ball Bearing 17x30x7mm

Stainless steel deep groove ball bearings: Designed to resist to corrosion, they are ideally suited for application in the food industry and anywhere that requires a bearing which is both hygienic and has a high resilience to water. These single row deep groove ball bearings have the same deep raceway grooves and close conformity between raceways and balls as standard deep groove ball bearings. They can carry axial loads acting in both directions in addition to radial loads, even at high speeds. Stainless steel deep groove ball bearings have the same running properties as conventional steel deep groove ball bearings, but have a lower load carrying capacity.The bearings are available in open and sealed designs for shaft diameters from 1 to 50mm.
Benefits: Food safe, water and corrosion resilient, available up to 50mm bore
Note: These bearings will eventually corrode in a marine environment and it is recommended to completely cover with grease or similar protection where practical. Due to the material requirements of these bearings to have a hard-wearing construction, they will be made of a harder form of Stainless Steel, such as 440 or similar, which will be attracted by magnets. Quotations for non-magnetic versions are available upon request.
Note: If your bearing has the code 6903/61903 on the races and/or seals but has an 18mm bore, then you may need a [MR183072RS]

Brand / Quality:

EU Budget - Economy Quality

Inside Diameter:

17mm

Outside Diameter:

30mm

Width:

7mm

Seals / Shields:

Rubber Sealed

Clearance:

* Standard